Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Any idea what hull this is  (Read 1709 times)

Stavros

  • Guest
Any idea what hull this is
« on: August 26, 2015, 02:39:09 pm »

Ok any idea what this hull is....having searched the net looking at Models by Design/Orion Mouldings and Kingstone mouldings for any clues I have come up Blankety Blank so to speak.....the Hulll used to be around 20mm longer ad sloped down towards the stern....I have cut this bit out so I can fit a shaft with a 60mm 4 bladed prop I am thinking a Trawler of sorts length of hull is 36ins and has a beam of 12ins ...any BRIGHT ideas on what it may be...Catherine want a PINK boat....daddy says no HA HA












Dave
Logged

john44

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,659
  • member of the Potteries Model boat club
Re: Any idea what hull this is
« Reply #1 on: August 26, 2015, 03:41:47 pm »

No idea what the hull is Dave but by the look on Catharines face it will definitely be pink,ha!ha?


John
Logged

Andyn

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 994
  • Location: Northamptonshire
Re: Any idea what hull this is
« Reply #2 on: August 26, 2015, 05:20:19 pm »

Isn't it one of those non-descript hulls 'SeaBreeze Boats' used to sell on ebay?
Logged

baloo

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 916
  • I`M YOUR FRIENDLY TRUCKER
  • Location: Grantham,lincs
Re: Any idea what hull this is
« Reply #3 on: August 26, 2015, 06:15:12 pm »

Minion or sponge bob boat please Daddy
Logged

Time Bandit

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 175
  • Model Boat Mayhem is Great!
  • Location: Deizisau, Germany
Re: Any idea what hull this is
« Reply #4 on: August 26, 2015, 06:30:41 pm »

No idea, but what the heck. Did somebody try to install a jet drive into this?
Logged
regards

Tobias

Stavros

  • Guest
Re: Any idea what hull this is
« Reply #5 on: August 26, 2015, 09:32:10 pm »

As I said in the first post I had to cut the Keel so I could put a shaft and a 60mm 4 bladed prop in it,as the keel carried on to the stern of the hull...Maybee it was intended for twin shaft running WHO knows that is not the question which is Does anyone have any ideas on it


Dave
Logged
Pages: [1]   Go Up
 

Page created in 0.113 seconds with 22 queries.