Apart from seating the servo, I have practiced my skills of painting. I am
re-ally afraid of starting the paint work
. What if I mess up..!
I also made bottom shields for my Action electronics. I am planning to use velcro to install them, the receiver and ESCs for easy reconfiguration, should I decide on such an endeavour in future. For instance, I may have to look for the optimal location for the Rx.
I also test-installed the push rods - and wondered, how the wingy things should be made at the rudder-ends...*
Explanation: The rudder shafts are just shafts with M3 thread at the top end. My local shop didn't carry the pushrod arm* for such. Seems ridiculous to order something like that over the mail. If I attempt to make them myself, I would have to be able to produce two identical, which is ten times more difficult than to make just one. I suppose, the arms should be soldered - I wouldn't trust glueing or thread-locking two nuts. - Should I?
* what is the term for the "pushrod arms"?