Electrics tray.
I reckoned there's plenty of room in the lower superstructure, so I built in 3 dimensions.
Everything is attached with velcro, except for the receiver tower and the elevated shelf of the P95 (motor power control), and the mains switch. For P92 (power distribution) the wires have to be unscrewed for the board removal.
Beneath there's a connector between P92 and the ESCs and the connector to the battery.
In to the below decks, there are cables for the rudder servo, motor power and the battery.
The pictures show the leds:
- On P95 both red and green are on: the motors are running in opposite directions, as per Tx programming.
- (other picture) On the ESCs the green lights are on: the motors have stopped (neutral) (At full throttle, both green and red lights are on.)
I wonder, how the Rx antennae should be hung. They shouldn't touch each other.