The Shipyard ( Dry Dock ): Builds & Questions > BMPRS - British Model Powerboat Racing Society
prop shaft on submerged drive hulls
Brigadair:
Thanks guys for the advice, much appreciated.
I'm running the boat with gap between hull and shaft which I think is what Bernard advises.
Cheers
Garry
triumphjon:
have you supported the outward tip of the tube ? i have "P" brackets fitted to my own boats
Brigadair:
Hi tri!
yes the end of the shaft is supported.
The shaft is supplied by Bernard, it comes complete with a quality welded "skeg".
Thanks for the info.
triumphjon:
do you have any photos of the bernard supplied shafts , ive been finding it difficult to obtain shafts from prestwich over the last year
Brigadair:
Hi
Sorry don't have a picture handy and not sure if Bernard is supplying them without boats???
They are 1/4" steel, with 5mm prop stud at prop end. The engine end has a brass hub which holds the ball race in place. The prop tube has a brass skeg hard soldered / braised on it. The Ballrace is held in place with a circlip which is handy to allow for easy removal and replacement of ball race if required.
Bernard's contact details are on the sales and wants page of BMPRS.co.uk..
I know the Prestwich ones are 5mm dia and excellent quality also.
Cheers
Garry
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version