Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: How to wire  (Read 728 times)

Skimmer Fan

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 291
  • Location: Wigan
How to wire
« on: August 02, 2016, 05:23:32 PM »

Could anybody tell me where the wiring should be going I assume the black red and White go to the receiver but then where does the  blue wire connect to.


Regards Bob
Logged
Regards
Skimmer Fan

microgyros

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 206
  • Location: Glasgow
    • microgyros website
Re: How to wire
« Reply #1 on: August 02, 2016, 06:02:32 PM »

A three wire battery connection with positive and negative supply, with respect to zero, is needed for ancient servo amplifiers. That was no longer the case in the 1970s when NE544 and ZN409 servo chips became available. You can open the servo case to see if the extra wire is redundant. I doubt it.
Logged
Pages: [1]   Go Up