Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Centering spring - Hitec optic 6  (Read 1540 times)

Skimmer Fan

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 302
  • Location: Wigan
Centering spring - Hitec optic 6
« on: March 21, 2017, 02:29:00 pm »
Is it possible to get a centering kit for the throttle arm on a Hitec optic 6 transmitter.
I have looked on the internet but cannot find such a thing.
Logged
Regards
Skimmer Fan

JimG

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,271
  • Model Boat Mayhem is Great!
  • Location: Dundee
Re: Centering spring
« Reply #1 on: March 21, 2017, 10:04:21 pm »
I've just checked the Optic 6 manual (available on line from Hitec USA).
Looking at the instructions on page 7 to change from mode 2 to Mode 1 it looks like the spring is already fitted to the arm. From the instructions after emoving the case back, remove the ratchet then loosen a tension spring hex screw on the opposite side of the stick unit.

Jim
Logged
Dundee Model Boat club

Skimmer Fan

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 302
  • Location: Wigan
Re: Centering spring
« Reply #2 on: March 21, 2017, 10:17:51 pm »
Jim
Thanks for that I will have a look inside tomorrow.
Logged
Regards
Skimmer Fan
Pages: [1]   Go Up
« previous next »
 

Page created in 0.085 seconds with 23 queries.