Hi there
,thanks guys the next lot of photos are.
1 ..With the first 4 frames i spliced flat sections of Tassie oak into their top section to take the planking above the deck level around the shoulders, and then ribbed this section only.
2 & 3 .. The remainder of her hull I fitted extra frames in between the main frames ,just for extra strength ( not that she needed it), I was able to use most of the cut outs from the main frames, bit of a slow job as each had to be shaped to fit that section of the hull, then I would cut them to the thickness I required before gluing them in , the inside of the hull was then was given 2 coats of resin.
4 .. Then framed and braced the sloped back section with Tassie oak .
5 ..Showing her with all her frames and ribs installed and the start (at the stern area) of installing her merbau shelving.
6 & 7 .. Sowing the shape of the merbau shelving around the flared section....