Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: updating victoria through hull roller wanted  (Read 2232 times)

portside II

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,523
  • tugs at rest
  • Location: Howden.East Riding of Yorkshire.England Near the banks of the river Ouse
    • goole model boat club indi site
updating victoria through hull roller wanted
« on: April 09, 2018, 12:38:53 pm »

Bought a victoria a couple of weeks ago and noticed the giudes for the sail lines are groved , i think it is something to do with the lines been braid and acting as a cutting effect on the guides.
So the plan is to fit one of theose through hull rollers in and make it an elastic tension rig if that what its called?,
but it's finding one . This is where you chaps come in , where can i get one please.
daz
Logged
I like to build my boats to play with, not to just look pretty, so they dont !

Netleyned

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,051
  • Location: Meridian Line, Mouth of the Humber
    • cleethorpes mba
Re: updating victoria through hull roller wanted
« Reply #1 on: April 09, 2018, 02:20:42 pm »

Nylet Sails will have what you need.
When I modded my Victoria, I epoxied a couple of
Beads into the deck holes and they have lasted
best part of 10 years.
Bought a bag of them from Boyes for a pound!


Ned
Logged
Smooth seas never made skilful sailors
Up Spirits  Stand fast the Holy Ghost.
http://www.cleethorpesmba.co.uk/

Howard

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,200
  • Location: Scotter Lincolnshire
Re: updating victoria through hull roller wanted
« Reply #2 on: April 09, 2018, 05:33:19 pm »


Daz I have a huge pile of pinted upgrades sheets I have for my Victoria and a bag of beads wish a nice hole in them  will pop them in the bike next time am at the club three weeks time .
                 Regards billy no mates aka Howard.
Logged

portside II

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,523
  • tugs at rest
  • Location: Howden.East Riding of Yorkshire.England Near the banks of the river Ouse
    • goole model boat club indi site
Re: updating victoria through hull roller wanted
« Reply #3 on: April 09, 2018, 10:38:51 pm »

Your a good man Howie, i dont care what they say  {-) .
Thankyou too for the advice Ned.
daz
Logged
I like to build my boats to play with, not to just look pretty, so they dont !
Pages: [1]   Go Up
 

Page created in 0.087 seconds with 22 queries.