Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Johnson Dark horse motors  (Read 2160 times)

Stavros

  • Guest
Johnson Dark horse motors
« on: August 19, 2007, 03:54:17 pm »

Right I have seen quite a few of these sold on ebay recently and wondered if anyone out ther has used them a sI am considering buiyng some for my Yorkshire man any comments cheer s

Stavros
Logged

Welsh_Druid

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 373
  • Location: Lleyn Peninsular North Wales
Re: Johnson Dark horse motors
« Reply #1 on: August 19, 2007, 04:16:50 pm »

If you mean those 600s with flux rings there are two in my trash box you are welcome to.  B- - - - - awful current hungry things.

Don
Logged

Shipmate60

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,800
  • You bark - I will bite!!!
  • Location: Fareham
Re: Johnson Dark horse motors
« Reply #2 on: August 19, 2007, 04:20:03 pm »

In a word Stav, DONT.
Not unless you want your tug to leave your Perkassa standing.
They are fast motors but VERY power hungry.
If you use them at all run on 6 volts with a heavy ESC.
On 12 volts they kill ESC's easily as they draw horrendous current.
Why not try the recommended geared motors?
On 12 volts they run at aprox 19000 rpm, but as stated on here previously the stall current is OVER 100 amps EACH.

Bob
Logged
Officially a GOG.

Shipmate60

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,800
  • You bark - I will bite!!!
  • Location: Fareham
Re: Johnson Dark horse motors
« Reply #3 on: August 19, 2007, 04:23:37 pm »

Stavros,
The geared 500 motors should power the yorkshireman with decent brass props.

Bob
Logged
Officially a GOG.

Andy_k

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 73
  • Location: Pembrokeshire
Re: Johnson Dark horse motors
« Reply #4 on: September 12, 2007, 06:51:34 pm »

Can always try the model motors direct they supply the 777 motor bearing at each end 7poles run really smooth and at 6v will turn a 50mm prop and only draw something  like 5amps amazing motors and the same size as a 540  O0
Logged
Right which one will I do next?;)
Pages: [1]   Go Up
 

Page created in 0.087 seconds with 21 queries.