no I haven't . Don't know how to do that.
I'll have another read of the manual.
1: What type of are you using ?
2: First step is to disconnect both ESC's
3: Use the Programming card to reset both of them and then set them to the desired function, in your case I'll guess it will be FWD only
4: Then you connect only one ESC and turn on the power Please make sure that the stick is in neutral (If you have removed the red wire please connect external power source)
5: The ESC should then first give you the amount of bib that is equal to the amount of LiPo cells you are using
6: Then it should bib bib until you move the stick to full power and you will get at bib confirmation that t is set. Then go back to neutral
7: Wait for a bib and you should be good to go (This is the "normal" way to do it at least with the ESC's I'm using.
8: Remove the ESC and repeat with the other one.
Br
Carsten