Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Pin Flow Glue Applicator  (Read 1375 times)

gyjoe

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 27
  • Model Boat Mayhem is Great!
  • Location: whitley bay
Pin Flow Glue Applicator
« on: May 23, 2017, 02:34:23 pm »

Hi All,
         As anyone used a pin flow glue applicator and if so what did they think of it?

                                                            Regards
                                                                         joe
Logged

Brian60

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,315
  • Location: Hull,UK-but currently residing in Los Martinez, Spain.
Re: Pin Flow Glue Applicator
« Reply #1 on: May 23, 2017, 04:00:47 pm »

I prefer cocktail sticks / toothpicks, much easier to control where it goes and if that is too big a drop to use -sometimes it is and you need more precise control. The use a sewing needle in the end of piece of dowel or even a pin vice.

BFSMP

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,091
  • Model Boat Mayhem is Great!
  • Location: Knott End on Sea
Re: Pin Flow Glue Applicator
« Reply #2 on: May 23, 2017, 06:03:27 pm »


Hi All,
         a pin flow glue applicator


what is one of those please............have you a picture of one. thanks,


Jim.
Logged
life is like arranging deck chairs on the Titanic!

Klunk

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,209
  • If you know who I am, please remind me!!
  • Location: luton, beds
Re: Pin Flow Glue Applicator
« Reply #3 on: May 23, 2017, 08:01:50 pm »

Yep use them all the time. I use the metal type with various diameters. Very good but do tend to block up easily fixed with a lighter in a well ventilated area.
I also use a plastic version that I buy from 5 star adhesives. The glue doesn't stick in these as often.
Both very good
Logged
SECRETARY - LUTON AND DISTRICT MODEL BOAT CLUB
full time penguin
Pages: [1]   Go Up
 

Page created in 0.098 seconds with 21 queries.