Slow project this
had a busy year so never got to finish the boat off.i changed a pump (original fault)
I replaced the old 40mhz to a flysky 6ch 2.4ghz Tx/receiver set ,also all the microcat electronics so now has a P92,P94,P111 diode board. also thinking of going down the LIPO battery line so i got a P103 parallel power board so 1 battery doesnt overcharge its twin.Ive also fitted a lucky fishfinder/sonar
whilst i still have it open.
now the muscle metal wire hopper release mechs work off power to generate heat to expand the metal wire, and original cable is a reasonable thick cable about 14awg, am i wrong in thinking plug/wires from an old servo to the receiver (if i went along that way) wont carry enough current to operate the release or am i just overthinking this. or is there an easier way.
and lastly i was thinking of putting a autopilot in this, i was looking at an toslon x-pilot but i cant find any info on whever it will run 4 sump pumps
maybe i will still be alive when i finish this.