Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: radio gear brackets  (Read 4079 times)

grendel

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,956
  • Location: Canterbury, Kent, UK
radio gear brackets
« on: July 16, 2017, 12:14:13 pm »
As I have plenty of bulkheads in my model, I decided to install the radio and servo in their own 3d printed mounts
Logged

Capt Podge

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 4,562
Re: radio gear brackets
« Reply #1 on: July 16, 2017, 10:16:23 pm »
That's a very neat solution Grendel - effectively "made to measure" :-)

Regards,

Ray.
Logged

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,900
  • Location: Kunming, city of eternal springtime, SW China.
Re: radio gear brackets
« Reply #2 on: July 17, 2017, 08:42:29 am »
Great idea, great mount  :-)) :-))
Logged
The only stupid question is the one I didn't ask

grendel

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,956
  • Location: Canterbury, Kent, UK
Re: radio gear brackets
« Reply #3 on: July 17, 2017, 09:21:58 am »
I did include a strap to stop it falling out, but its a good tight fit and didnt need it.
Logged

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,900
  • Location: Kunming, city of eternal springtime, SW China.
Re: radio gear brackets
« Reply #4 on: July 17, 2017, 11:52:44 am »
I was thinking that maybe they were snap fit. Even if not, a small lip on the inside edge of the bracket, just above the widest part of the case of the item to be held, would be a two minute mod.
I noticed that Sketchup now has a template for 3D printing. Which is cool.
Logged
The only stupid question is the one I didn't ask
Pages: [1]   Go Up
« previous next »
 

Page created in 0.014 seconds with 20 queries.