Neil I am very surprised at what you have said about Gorrilla glue as Ive been using this for a couple of years....YES of course the Brown Gorilla glue is a right so and so as it expands but their Pva is darned good and also both the superglue's...once it's on it is on
Dave
sorry dave but just my opinion...
the brown bubbly stuff activated by moistire has never worked for me, even when clamping, and it takes longer to clean off excess than the gluing time...
.thus wasting twice the time...
.and TBH it doesn't resist knocks such as dropping your hull on the floor due to clumsiness.
the white pva I have found, although good sticking power takes too long to set compared with a good aliphatic.
the superglue sticks fingers instantly and not even my cyano release liquid will help, but once set is very brittleand the slitest knock just shatters the glue line and the thing glued falls apart.....
as for the duct tape......I have used numerous duct tapes that will adhere to my silicon moulds for casting fittings when I have got fittings too close to the edge of a mould, and the tape has always stuck to the silicon...
...gorilla duct tape just don't cut it...
..it sticks to itself admirably, to admirably that it leaves half its stickiness to the next layer down, but to timber and silicon and for any other target that I can think I have used it on...
.I get better sticking bower from a roll of cellotape
.
i'll never buy the stuff again in any form.