Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: has any one built billings calypso  (Read 1110 times)

merseyferry

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 354
  • Location: liverpool
has any one built billings calypso
« on: October 11, 2017, 12:39:18 PM »

hello i an still rebuilding calypso  and i have not got the build manual, my question is  when fitting the hulls obsevation chamber , do i cut into the hull to fit the chamber, or  cut the chamber to fit hull pic 1 is bottom of hull were chamber goes  pic 2 is the obsevation chamber still on plastic card  best regards pat '....... ps if any one needs any lost parts for calypso i might be able to help
Logged

Paul2407

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 310
  • Model Boat Mayhem is Great!
  • Location: Sunny South
Re: has any one built billings calypso
« Reply #1 on: October 12, 2017, 07:43:32 AM »


Not actually built one but a model I have looked at closely over last few years and I was lead to believe it was stuck around it, I don't think you have to cut the hull? and I would think if you did it would leave a weak spot on the hull as the slightest bump up front could dislodge it


but that is only my opinion, hope you find out a definitive answer


Cheers
Paul
Logged

terry horton

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 81
Re: has any one built billings calypso
« Reply #2 on: October 12, 2017, 09:39:40 AM »

You can find a build manual on Manuall.co.uk
Regards
Logged

merseyferry

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 354
  • Location: liverpool
Re: has any one built billings calypso
« Reply #3 on: October 12, 2017, 10:51:37 AM »

thank you for your reply gents(paul,terry) ive down loaded the plans and will paint before i fit to hull best regards pat
Logged
Pages: [1]   Go Up