Took advantage of the 1 mild day we had, to get the window frames sprayed and once hardened off these were finally glued in place with cyano - took 3 attempts to get 2 of them to stick, this was due to my forgetting to key the surfaces
The drivers control panel was also given a couple of coats of Fiat Bianco Bossa Nova White (Halfords)
While that was drying off, made a couple of test prints for the dashboard and throttle - these looked ok so the waterslide transfers were made and the dashboard panel made with scrap mahogany.
This was then given 2 coats of varnish.
Now came a slight snag...the transfer sheets are of the 'clear' type, so anything white disappears from the transfer - that's because the printer doesn't actually print in white. In this instance it meant that the dials and pointers on the instruments would not show so, to get around this I simply made a white panel (slightly smaller than the mahogany) and applied the transfer to that...Bingo!
So now, all 3 transfers were applied - 1 on dash, 1 on lower console and 1 on the throttle body.
Finally, the steering wheel was simply glued to the body and that's the console done . The throttle levers just need a bead or similar adding.
Next will be the cockpit doors....