Now then, I usually leave the window glazing to near the end of a build but, I thought it would be better to do it now, before the little bits and pieces get added to the saloon tops.
Well, when I tried to do the first side I found that I couldn't get the plastic to sit firmly on the apertures. this was due to the way I'd built the inner coaming which, due to my bad planning, was in the way and too difficult to remove without causing too much damage.
So now, my only other option was to remove the window frames and stick the 'glass' to the inside of them.
As a consequence, I've given myself more work to do - both the frames and the structure sides and ends will need rubbing down again and respraying - I'll get cracking with that this evening...
...a few photos attached.
Ray.