Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: TVR1BB Engine build  (Read 2292 times)

xrad

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 564
  • Keeper of the Sun Dried Tomato
  • Location: Ohio USA
Re: TVR1BB Engine build
« Reply #25 on: April 18, 2018, 09:55:19 PM »

I used locktite blue bottle on linkage associated screws. Rest are just snugged tight. And also never got email replies to any questions.
Logged

ooyah/2

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 578
  • Location: Glasgow
Re: TVR1BB Engine build
« Reply #26 on: April 19, 2018, 06:00:28 AM »

{. And also never got email replies to any questions.}


xrad,
What were your questions as they are not listed in this  thread.?


George.
Logged

KNO3

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,158
  • Location: Vienna
Re: TVR1BB Engine build
« Reply #27 on: November 04, 2018, 11:07:27 AM »

Does anybody have experience of suggested weight/size for a flywheel?

My Tvr1a engine runs quite well without a flywheel. However, I had the marine flywheel offered as option by Graham, but since it looked so plain, I had it machined with a recessed face and a groove for a belt.
Logged
Pages: 1 [2]   Go Up