Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Ply  (Read 3872 times)

Gardener

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 179
  • Location: Runcorn
Ply
« on: October 05, 2018, 03:06:33 pm »
just ordered some ply from Slec to start on a Springer Tug, my first build project from scratch ...
Logged

nemesis

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,086
  • Location: North Shields. Northumberland
Re: Ply
« Reply #1 on: October 08, 2018, 04:18:08 pm »
Hi, Select the best side. There is always a good side, then grain fill and "sand and seal" the sheet or piece that you are going to use. It is much easier to do it on the flat rather than when the object is constructed. Got the T shirt. if you know all this I am truly sorry. nemesis
Logged

Gardener

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 179
  • Location: Runcorn
Re: Ply
« Reply #2 on: October 08, 2018, 05:48:10 pm »
Thanks  :-))
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.084 seconds with 21 queries.