Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Help Required with Action P94  (Read 1232 times)

jumpin_jack

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 52
  • Location: West Sussex
Help Required with Action P94
« on: April 29, 2020, 07:30:42 pm »
Hi Guys, old age is getting to me and I'm trying to recreate this set up for my Happy Hunter.
The only change I've made is to run it on a 6 volt battery rather than 12, my issue is with the P94 distribution board, now the RX power input lead that comes from the p94. How does it connect to the whole system? is it via the RX or does the battery pack plug straight into the P94?
apologies if this sounds basic but its been a while :-))
Phil

https://action-electronics.co.uk/wp-content/uploads/2019/04/Basic%20P94%20set-up%20with%20bow%20thruster.pdf
Logged

david48

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 866
  • Location: Strathdon,Aberdeenshire
Re: Help Required with Action P94
« Reply #1 on: April 30, 2020, 01:47:45 am »

Are you using a P102 distribution board .
David
Logged
Two heads are better than one sheep head  as my old plant manager used to say

DaveM

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 711
  • Why on earth do I do this?
  • Location: Nottingham
Re: Help Required with Action P94
« Reply #2 on: April 30, 2020, 08:34:47 am »
P94 is the dual ESC, not the power distribution board (that's P102). You don't need a separate Rx battery pack. As per the legend on the diagram, the two-wire flylead from P102 plugs into the receiver in the socket where you would usually connect a 4-cell pack. This is usually marked "Batt" or similar. As long as your installation mirrors the diagram then everything should work OK.

DaveM
Logged

jumpin_jack

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 52
  • Location: West Sussex
Re: Help Required with Action P94
« Reply #3 on: April 30, 2020, 03:09:31 pm »
Hi Dave, Thank you for the help, i must apologise, yes it is the P102 distribution board that i was referring to.
I just didnt want to go for it only to find that i blow something up. :-))
So just to clarify i can run the whole set up from the 6 volt lead acid battery used to run the motors?
regards
Phil
Logged

coch y bonddu

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 376
  • Model Boat Mayhem is Great!
  • Location: Bethesda
Re: Help Required with Action P94
« Reply #4 on: April 30, 2020, 03:49:13 pm »
yes you most definitely can




Dave
Logged

jumpin_jack

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 52
  • Location: West Sussex
Re: Help Required with Action P94
« Reply #5 on: April 30, 2020, 06:50:12 pm »
Thanks again chaps, looking forward testing on the local pond when all this is over :-))
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.089 seconds with 22 queries.