Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Tamar propellers  (Read 1876 times)

ajb63

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 44
  • Model Boat Mayhem is Great!
  • Location: Cambridge
Tamar propellers
« on: May 09, 2019, 04:38:51 pm »

Want to change to brass propellers on Model Slipway 1/16 Tamar Lifeboat.
Lost one of the original plastic propeller supplied in kit , and looking at Roboesch 40mm brass as replacements . Not sure whether to go for 3 or 4 blades and type A or C Type props. Good speed from the supplied props with kit running with brushless Tornado 3536 1050kv on 3s lipo. Any recommendations of what go for would be helpful. Thanks
Alan
Logged

ajb63

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 44
  • Model Boat Mayhem is Great!
  • Location: Cambridge
Re: Tamar propellers
« Reply #1 on: May 13, 2019, 09:16:23 am »

There must be someone on the forum to give suggestions on propellers.
Thanks Alan
Logged

morley bill 1

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 300
  • Model Boat Mayhem is Great!
  • Location: east yorkshire coast
Re: Tamar propellers
« Reply #2 on: May 13, 2019, 09:54:53 am »

I would speak to sibmon at propshop I use them for all my props and have never been disappointed  Bill..
Logged

minimariner

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 106
  • Model Boat Mayhem is Great!
  • Location: lincolnshire
Re: Tamar propellers
« Reply #3 on: May 13, 2019, 09:38:59 pm »

Alan,
         The photo`s are of 16-07 RNLB Lester, Cromer Lifeboat.
          The photo of the real boat was taken just before the anti-
          fouling was changed to white.

          The model photo shows brass 40mm 5 blade props from Prop Shop.
           Hope this helps.

          Bryan.
Logged
Pages: [1]   Go Up
 

Page created in 0.119 seconds with 22 queries.