Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Motor Control  (Read 2488 times)

Stavros

  • Guest
Motor Control
« on: May 22, 2006, 11:07:19 PM »

Right having seen my mate's raido controlled bait boat it got me thinking,no way I will pay ?400+ for that piece of poo poo,I can do better but how?.The controller was a 2 channel,the boat in question was a catermerang,powered by 2 motors,the left hand stick controlled the forward motion with both motors working ahead,when you wanted to turn left/right one motor would slow and the other speed up,if stationary and selected for example left, one motor would go astern and the other ahead ,how the heck do you do this.?I have got a 3 channel set ready to be used in my next project which is a bait boat but how do I get it to do as described above cheers Satvros
Logged

John W E

  • I see no ships !!
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 8,504
  • Location: South shields
Re: Motor Control
« Reply #1 on: May 22, 2006, 11:51:03 PM »

Hi ya mate,

little thing in your mate's boat that does the trickery is called a MIXER - it goes between your RX (receiver) and speed controllers for the motors.   There are a few of them around i.e. different makes ACtion is one, Hunter and also others.

Fairly straightforward to fit - and cost about ?18 for a diy kit that you put together yourself, ?24-?25 for a ready made one.

Aye
John E
BLUEBIRD
Logged

barriew

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,009
  • Location: Thaxted, Essex
Re: Motor Control
« Reply #2 on: May 23, 2006, 02:00:58 PM »

... or depending on which 3 channel Tx you have, it might have mixing built in! Most Hitec 3 ch 40 mhz sets do.

Barrie
Logged
Pages: [1]   Go Up