The Shipyard ( Dry Dock ): Builds & Questions > Bait Boats
Motor responds and runs full throttle only
(1/1)
Warrior:
this is on a viper bait boat,
But I’d imagine it’s a general rc problem. I’ve been fixing mine and my friends boats for a while but I’m stumped.
If I turn in the hand set and then the boat, the left motor runs forward if I push forward on the hand set, if I pull the stick back motor runs backwards but won’t stop in the middle, other motor is fine. Everything else works perfect,
I’d thought speed controller but I can't find any, there is a control PCB and that’s it,
I’m thinking it’s the pcb but don’t really know how to diagnose the fault.
Thanks in advance.
I have a spair handset and rec, but them on and it would not control anything,
coch y bonddu:
Sounds to me that the circuit board has gone dullaly....no cure for it bin it and either put a new one in Or get rid of all the wiring and start again with proper rc gear....done quite a few of the vipers.
Dave
Warrior:
What i thought, for a quick fix, could I buy 2 speed controllers and wire then to the motors and in the receiver to by pass that part of of the pcb? It’s tank type steering so am I right in thinking I wouldn’t need a mixer?
Navigation
[0] Message Index
Go to full version