Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: tamar build  (Read 130 times)

howard66spary

  • Shipmate
  • *
  • Offline Offline
  • Posts: 7
  • Model Boat Mayhem is Great!
  • Location: mildenhall
tamar build
« on: November 23, 2019, 12:26:31 PM »


Hi Think I have some Perspex parts in the right place ell ow Modelers
Thanks to all who have read my recent post regarding Tamar wheel house build

I think I have some of the Perspex parts in the right place but a four  parts are  a mystery  , sheet b part number 77 the four  parts  in question are small the

triangular pieces, two large sections with semi curves cut out one with two slots cut out to receive the triangular sections

Just  couple more query's , what will be the best too  glue to fix   the perspex parts too the  fibre glass
A drawring  or photo would be most helpful
This query was also part of my pevious post  the sloping walls of the weheelhouse  where Perspex panels are glued in have about a 6mm flange are these reduced when the pespex infills are fitted or left 6mm wide 


Please help if you can  <:(
Best regards
h  spary

Logged
Pages: [1]   Go Up