Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Drumbeat on brushless  (Read 1320 times)

ChrisH1981

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 67
  • Model Boat Mayhem is Great!
  • Location: Kidderminster UK
Drumbeat on brushless
« on: December 05, 2019, 08:09:47 pm »
After reading all your informative comments on my previous post, I have decided to install a brushless setup in the drumbeat of Devon. I’ve been doing some calculations and I’m looking at a 1400kv motor running on a 2s lipo (in the region of 4000mah). This should give me a no load rpm of 10360.
A few questions I have in mind are, is the 10360rpm still too much for my prop size of 40mm 4 blade, and will the motor I’m looking at have enough torque?


This will be a twin esc setup with separate battery packs.
This is the motor I am looking at, I have to keep the can diameter to a minimum.
https://hobbyking.com/en_us/propdrive-v2-2836-1400kv-brushless-outrunner-motor.html?wrh_pdp=7
Logged

unbuiltnautilus

  • Portsmouth Model Boat Display Team
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,157
  • Location: Portsmouth, England, third rock from the Sun....
Re: Drumbeat on brushless
« Reply #1 on: December 05, 2019, 08:46:26 pm »
I feel we have been here before %)


I would suggest about 950 to 1100kv, just going on past experience.
Logged
Listen politely, nod approvingly, then do what you want, works for me!

ChrisH1981

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 67
  • Model Boat Mayhem is Great!
  • Location: Kidderminster UK
Re: Drumbeat on brushless
« Reply #2 on: December 05, 2019, 08:52:09 pm »
 :-))  Ok unbuiltnautilus
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.101 seconds with 22 queries.