Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Cutting side panels  (Read 2793 times)

dave parker

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 197
  • Location: Stockton on Tees
Cutting side panels
« on: January 17, 2020, 08:13:09 pm »

hi all


When cutting your marching sides for springers do you....


Cut two sides close to the line, clamp together and shape together


Or


Clamp two sheets together and then cut and sand to shape?


I did the first one, but sanding through  2x6mm  sheets is a challenge even if only removing a mom.


Any advice???
Logged

CGAux26

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 655
  • Location: Deep in the heart of TEXAS (Tomball)
Re: Cutting side panels
« Reply #1 on: January 17, 2020, 09:19:25 pm »

I would clamp the two sheets together and keep them that way until all sanding of the edges is done.
Logged

Klunk

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,278
  • If you know who I am, please remind me!!
  • Location: luton, beds
Re: Cutting side panels
« Reply #2 on: January 18, 2020, 05:37:59 am »

being lazy, i had mine laser cut
Logged
SECRETARY - LUTON AND DISTRICT MODEL BOAT CLUB
full time penguin
Pages: [1]   Go Up
 

Page created in 0.104 seconds with 22 queries.