Hello.
Hull glassed now and rubbed down, 1oz cloth on the bottom and transom with 1/2oz on the sides.
2 coats of Z Poxy finishing resin unthinned, rubbing down between coats, no need for thinning as I always sand the majority of the resin away.
Have marked out the position of the lifting strakes on one side with tape and given it a dusting of primer, which also shows any surface filling that might be needed.
Fortunately, all looks good so none needed.
The photos show the results and the positioning of the strakes and the main spray rail that is already built into the hull sides.
Also, picture for ChisF of the bow flair.
Mike.