Good Morning All
Hope all are keeping safe and well
Now that i have more time thought i would get on with my 1/12 speedline tamar wheelhouse , i think the question has been asked before but will try again as once glued could be a problem
1 The fibreglass wheelhouse moulding as supplied with sloping rear walls port and starboard have a flange of about 12mm ,are these reduced to match the 1,5mm perspex infill panels as supplied ( the 1/12 scale drawings show it reduced to about 5mm )
2 Has any one got the measurement required for part number 31 rear storage wall to rear of wheelhouse this is quite critical
Thanks Hope someone can help
Best regards keep safe
H W Spary