Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Replacement Springs Stuart Turner Twin Oscillator  (Read 1030 times)

DBS88

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 492
  • Model Boat Mayhem is Great!
  • Location: Surrey
Replacement Springs Stuart Turner Twin Oscillator
« on: May 31, 2020, 10:40:06 pm »

Have just had a look for replacement springs for a Stuart Turner Twin Oscillator, three needed, the part number is 60074 and looks to be £7.35 each.


Has anyone replaced theirs? If so which springs did you use and where can I get them? Any ideas welcome, I believe they are made from phosphor bronze. Thank you
Logged

Seacommander

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 100
  • Model Boat Mayhem is Great!
  • Location: Nottinghamshire
Re: Replacement Springs Stuart Turner Twin Oscillator
« Reply #1 on: May 31, 2020, 11:00:05 pm »

I have a vintage Bowman steam launch that came to me with the drive spring from engine to shaft.
I panicked a bit to be honest and asked the same question on another forum
The answer came back look eBay, there are several manufacturers that sell on there and they list  thousand of sprigs 
Logged
Pages: [1]   Go Up
 

Page created in 0.122 seconds with 21 queries.