Topic: 'Four Ways' cargo ship (Read 7421 times)

Andy M · « **Reply #75 on:** October 27, 2021, 12:11:55 am »

Here is my 3d printed cannon, I am not very inventive when it comes to painting.
I carved a pair of tiny bamboo oars for my lifeboat,pretty fiddly. I think the rest of the oars must have washed overboard😁
I might end up making more at some point.

Andy M · « **Reply #76 on:** November 01, 2021, 06:51:14 pm »

While I am showing some 3d printed stuff, I thought I would show this little outboard, non functional but pretty good looking. I have left the prop loose enough to spin in the water.
I left prop red so it might be seen better.

I will be trial fitting the outboard on my Edita cruiser as a fake auxilliary engine to see how it looks. Quite impressed how my printing filament thumbscrews turned out. Just heated and squeezed flat.
Although this outboard isnt functional, I have plans........

News:

Author Topic: 'Four Ways' cargo ship (Read 7421 times)

Andy M

Re: 'Four Ways' cargo ship

Andy M

Re: 'Four Ways' cargo ship