Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Shannon build query  (Read 901 times)

Pragmatist

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 89
  • It's a nautical thing
  • Location: Ipswich, Suffolk
Shannon build query
« on: April 08, 2021, 07:26:39 pm »
I was lucky enough to acquire a 1/12th Shannon and am about to take it to my local model shop for them to fit speed controllers and rx. The jets are KMB 28’s. Would there be anything my local shop would need to know just in case they haven’t dealt with this kind of propulsion system before?

Thanks,

Matt
Logged

chipmonk

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 49
  • while you are here, can you just!
  • Location: West Sussex
Re: Shannon build query
« Reply #1 on: April 09, 2021, 02:42:55 pm »
Hi there, The instructions that come with these drives say not to run them out of the water except for at low speeds and for the shortest time. Also not to exceed 20,000 rpm on full power.
Cheers Chris M
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.094 seconds with 21 queries.