Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Hobby king ORX transmitter module  (Read 582 times)

john44

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,659
  • member of the Potteries Model boat club
Hobby king ORX transmitter module
« on: May 05, 2021, 03:26:15 pm »

Hi guys, a friend of mine is trying to fit the above module to his Robbe F14 40 MHz transmitter
Has anyone fitted this 2.4 MHz module to their 40 MHz transmitter.
My friend cannot remember what he did with the wiring instructions so if anyone can help
He will be very grateful


John
Logged

C-3PO

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,107
  • I thought that hairy beast would be the end of me
  • Location: Outer Rim world of Tatooine
Re: Hobby king ORX transmitter module
« Reply #1 on: May 05, 2021, 05:11:39 pm »

Hi John,

Assuming it's like the module in the picture it's pretty simple



The module only has 3 wire that can be connected - they are terminated in female sockets wrapped in black heat shrink - they will slip onto the header pins inside the F14

The colours are consistent with most RC equipment - like a servo

The supply voltage range is 6.0-15.0V

Orange = PPM signal
Red  = + positive supply
Brown = - negative supply



Oh - and this was the instructions in the box I had - just be careful with the " connectoted "!!!! :)







Regards
C-3PO
Logged
I think it's the way I have learnt most of my stuff - getting very stuck first...
Pages: [1]   Go Up
 

Page created in 0.096 seconds with 22 queries.