Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Best tools for removing work hold tabs form CnC cut plywood parts  (Read 938 times)

dillinger 04

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 103
  • Model Boat Mayhem is Great!

Hello everyone


I am currently working on a wood model boat kit, I have removed the work hold tabs, from the 3mm plywood sheet parts, and ready to finish up removing what is left behind of the tab parts remaining. Any expert advice experience for best tools to use to do the job right as for good clean results would be appreciated
David
[size=78%] [/size]
Logged

Baldrick

  • Full Mayhemer
  • *****
  • Online Online
  • Posts: 1,414
  • Model Boat Mayhem is Great!
  • Location: Nether Effingham (Perfideous Albion)
Re: Best tools for removing work hold tabs form CnC cut plywood parts
« Reply #1 on: September 13, 2021, 10:21:17 pm »




   My tool of choice for that is the Veritas low angle thumb plane but if you do not have one or wish to spend out £45 a nice sharp small chisel will do the job as well providing you are careful.




Logged
And everyone thought it was IVAN who was terrible

ukmike

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 445
  • I used to be indecisive... but now I'm not so sure
  • Location: Gorleston Norfolk
Re: Best tools for removing work hold tabs form CnC cut plywood parts
« Reply #2 on: September 13, 2021, 11:20:54 pm »

The wood seems to be lite ply, if so, then you can't beat a good quality Scalpel.

A Swann Morton handle No.3 with 10a blades is ideal.


Mike. 
Logged
Pages: [1]   Go Up
 

Page created in 0.085 seconds with 22 queries.