Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Leveling bed  (Read 756 times)

JaS

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 80
  • Location: Gothenburgh,Sweden
Leveling bed
« on: September 17, 2023, 10:13:42 pm »

Hello
Question for you 3D guys.
How often do you level yours beds?


Cheers
Jack
Logged

Subculture

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 4,188
  • Location: North London
    • Dive-in to Model submarines
Re: Leveling bed
« Reply #1 on: September 17, 2023, 10:41:15 pm »

I locked my bed. Removed the springs and shimmed it until it was as level as I could get it. With the standard sprung rig, it was always going out of whack. I also run a bed levelling sensor.
Logged

Umi_Ryuzuki

  • Full Mayhemer
  • *****
  • Online Online
  • Posts: 1,397
  • Location: PDX, OR USA
    • Models and Miniatures
Re: Leveling bed
« Reply #2 on: September 18, 2023, 07:26:54 am »

When a new print fails to adhere... ok2

Andyn

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,002
  • Location: Northamptonshire
Re: Leveling bed
« Reply #3 on: September 18, 2023, 08:30:05 am »

After every time I print something that takes up most of the bed space, before printing something big or after my other half has Ďdelicatelyí taken something off the bed {-)
Logged

big_bri

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 308
  • Location: Dumbarton, Scotland
Re: Leveling bed
« Reply #4 on: September 18, 2023, 11:11:50 am »

I have a new Ender 3S1, after initial setting up, Iíve never had the need to. Going on twenty odd prints now. My old Ender3v2 printer  only needed levelling a few times in the three years Iíve  used it. Iím in the process of upgrading it just now to run alongside the S1, itís a great little printer and has proved faultless since I got it.
Logged
-----------------------------------------------------------------
Brian
Pages: [1]   Go Up
 

Page created in 0.086 seconds with 21 queries.