Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: tamar boat hooks housing  (Read 809 times)

howard66spary

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 51
  • Model Boat Mayhem is Great!
  • Location: mildenhall
tamar boat hooks housing
« on: February 14, 2024, 03:55:20 pm »

Good Afternoon Fellow lifeboat builders                                                                                                  Sorry for another question about to assemble the boathook etched parts supplied by silverline  i understand most other parts supplied but try as i may there are 4 small brass squarish brass parts with one rounded corner try as i may i cant see how they marry up with retangular brass parts which have two rounded corners                                                                                                                                                                          Any help would be most appceated                                                                                                      thanks howardspary 66
Logged

6705russell

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,482
  • Model Boat Mayhem Forum is the Best!
  • Location: Staffordshire
Re: tamar boat hooks housing
« Reply #1 on: February 14, 2024, 04:57:37 pm »

Do you have a picture of the brass pieces?
Logged

howard66spary

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 51
  • Model Boat Mayhem is Great!
  • Location: mildenhall
Re: tamar boat hooks housing
« Reply #2 on: February 14, 2024, 06:38:12 pm »

Thanks russell6705                                                                                                                                                                                                                                                                                       The only drawing i have is the sheet  supp;lied by speedline refersance hooks covers and clasps  shown on paper sheet number 49 parts are 0,3mm brass                                                                                                                                                                                                                                                     Thanks for your reply howardspary66
Logged
Pages: [1]   Go Up
 

Page created in 0.102 seconds with 22 queries.