Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Hobbywing 1060 receiver  (Read 1053 times)

terry1956

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 173
  • Model Boat Mayhem is Great!
  • Location: yeovil
Hobbywing 1060 receiver
« on: March 07, 2024, 04:41:02 pm »
Hi, I have a problem with the hobbywing 1060 I purchased. No matter which position I set the tag it will only run in one direction. Why is this, and is there a way to get reverse.
Logged

Klunk

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,287
  • If you know who I am, please remind me!!
  • Location: luton, beds
Re: Hobbywing 1060 receiver
« Reply #1 on: March 08, 2024, 06:53:02 am »
Is the throttle in the center on your transmitter?
Logged
SECRETARY - LUTON AND DISTRICT MODEL BOAT CLUB
full time penguin

terry1956

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 173
  • Model Boat Mayhem is Great!
  • Location: yeovil
Re: Hobbywing 1060 receiver
« Reply #2 on: March 08, 2024, 08:19:32 am »
Yes its all starts from the centre position
Logged

Klunk

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,287
  • If you know who I am, please remind me!!
  • Location: luton, beds
Re: Hobbywing 1060 receiver
« Reply #3 on: March 08, 2024, 08:52:43 am »
Is the jumper  set to F/b/r not F/B
Logged
SECRETARY - LUTON AND DISTRICT MODEL BOAT CLUB
full time penguin

HMS Invisible

  • MICROGYROS.COM
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 630
  • Location: Paisley, Renfrewshire
    • Yes, it works!
Re: Hobbywing 1060 receiver
« Reply #4 on: March 08, 2024, 10:05:46 am »
WP-1060-BRUSHED at F/R MODE requires the MODE jumper completely out.
Logged
< All manner of contact methods over to the left.

Fred Ellis

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 459
  • Model Boat Mayhem is Great!
  • Location: West Sussex
Re: Hobbywing 1060 receiver
« Reply #5 on: March 08, 2024, 10:07:18 am »
Hi
The layout on my 1060 is;

When looking at the ESC have the R/X lead to the bottom, you will have the settings just above the R/X lead, to the left you have the setting pins, the top three should have no jumper, the bottom three pins should be left pin free middle and right pin should be covered by the jumper.


Hope that this is of some help
Fred
Logged
That's all right, Mr Ryan. My Morse is so rusty, I could be sending him dimensions on Playmate of the Month.
Pages: [1]   Go Up
« previous next »
 

Page created in 0.103 seconds with 22 queries.