Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: glue brass to perspex  (Read 3376 times)

howard66spary

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 51
  • Model Boat Mayhem is Great!
  • Location: mildenhall
glue brass to perspex
« on: September 20, 2023, 07:00:51 am »

Good Morning Fellow Modelers                                                                                                                                                                                                                                                          I am working on the bridge stairs of my speedline tamar this consists of perspex treads fixed to brass sides i have tried the following glues without any joy ( araldite expoy E6000 gorilla super glue liquid ) i have seen posts for small etched parts to be fixed with super glue is this ok there are quite a lot of perspex to perspex parts also so any suggestions would be most welcome                                                                                                                                                    Thanks  :((          Best Regards howard66spary
Logged

gingyer

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,697
  • Location: Glasgow
Re: glue brass to perspex
« Reply #1 on: September 20, 2023, 10:16:39 am »

I have used this to glue etched parts to plastic with no issues




https://www.snmstuff.co.uk/product/mig-ammo-ultra-glue-for-etch-clear-parts-and-more/




Logged

Mark T

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,140
  • Location: Dudley in the Black Country
Re: glue brass to perspex
« Reply #2 on: September 21, 2023, 07:46:25 pm »

Martin (Admin)

  • Administrator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 23,731
  • Location: Peterborough, UK
    • Model Boat Mayhem
Logged
"This is my firm opinion, but what do I know?!" -  Visit the Mayhem FaceBook Groups!  &  Giant Models
Pages: [1]   Go Up
 

Page created in 0.086 seconds with 22 queries.