Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: Jet drive Pibber  (Read 9374 times)

colin-stevens

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 731
  • Location: Southwater
Re: Jet drive Pibber
« Reply #25 on: May 18, 2008, 08:18:47 pm »

Couple of shots of her running. forgive the unpainted bits. Great fun, but realy wet boat. frequent pit stops to drain her out.
Logged
grumpy old XXX

Sub driver

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 612
Re: Jet drive Pibber
« Reply #26 on: May 23, 2008, 11:10:40 am »

Glad you got her up and running....

You may wish to consider putting some spray rails on ...I did and it cuts down the spaying into the boat ..just a thought for you ? O0
Logged

colin-stevens

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 731
  • Location: Southwater
Re: Jet drive Pibber
« Reply #27 on: May 23, 2008, 08:54:32 pm »

just finished sealing the rear deck. hope that helps. where did you put the rails?
colin
Logged
grumpy old XXX

Sub driver

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 612
Re: Jet drive Pibber
« Reply #28 on: May 24, 2008, 10:48:47 pm »

Hi Colin,
If you look at the first pic of mine , you can just see them, one on the waterline and one on the bottom of the hull / side, it did help mine.

Regards Sub 
Logged

bbdave

  • Guest
Re: Jet drive Pibber
« Reply #29 on: May 30, 2008, 04:25:35 pm »

Looks good colin what set did you use inside motor and battery wise

Dave
Logged

colin-stevens

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 731
  • Location: Southwater
Re: Jet drive Pibber
« Reply #30 on: May 30, 2008, 06:56:10 pm »

used the set up from Kehrer. check out the site. running tome on 8.4v 4.6a/h more than adequate, 20 mins. does not like "dirty" water. clogs up, overloads the speed controls and stops.
colin
Logged
grumpy old XXX
Pages: 1 [2]   Go Up
 

Page created in 0.108 seconds with 22 queries.