Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: korz nozzle  (Read 2288 times)

colin-stevens

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 693
  • Location: Southwater
korz nozzle
« on: July 13, 2006, 09:59:09 PM »

Hi, can you help. I am looking for a nozzle about 65mm tapering to 48mm do x 37mm in length. These are not critical a bit either way on any measurement will be good enough. Any help would be gratefully accepted. was going to spin me own up but turns out the lathe i have acssess to wont spin that big. killed me project stone dead.
 
Thanks in advance
Colin
Logged
grumpy old XXX

Shipmate60

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,233
  • You bark - I will bite!!!
  • Location: Fareham
Re: korz nozzle
« Reply #1 on: July 13, 2006, 10:55:10 PM »

Scoonies sell Korts.

Bob
Logged
Officially a GOG.

DavieTait

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,110
  • Location: Fraserburgh
    • Trawlerphotos
Re: korz nozzle
« Reply #2 on: July 14, 2006, 12:00:11 AM »

Well looking in the most recent Scoonies catalogue they list a Nozzle that should suit you.

Page 15 , code number BS ( no not joking !! ) : Kort Nozzle 50mm internal diamere at rear : price : ?11 +p&p
Drop Andy an Email to check this is what your looking for: andy@scoonie-hobbies.co.uk
or they're website : www.scoonie-hobbies.co.uk

Davie
Logged
Davie Tait,
Scotland
Site Admin www.trawlerphotos.co.uk

norry

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 866
  • ...Get Your Tugs Out For The Bouys...
  • Location: Paisley Scotland
Re: korz nozzle
« Reply #3 on: July 14, 2006, 12:51:49 AM »

Mobile Marine Models in Lincoln do a nice range of Kort Nozzles...their number is 01522 730731... or 01522 689209...Tell them Norry sent you...

REGARDS...Norry Mason...
Logged
...Get Your Tugs Out For The Buoys...

colin-stevens

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 693
  • Location: Southwater
Re: korz nozzle
« Reply #4 on: July 15, 2006, 06:56:56 PM »

new i could rely on you guys. sent an e-mail of to mobile marine in the week, waiting for a reply. just walloped one of to Skoonies. ordered one from my local shop today, the robbe one at 50mm. lets see. hope it works out.
cheers onsa and all

colin
Logged
grumpy old XXX
Pages: [1]   Go Up