Technical, Techniques, Hints, and Tips > DC Motors (Brushed) and Speed Controllers
Hitec "Gold brick" ESC's
gingyer:
I have a few of the old hitec esc that are the gold brick ones
can anyone remember the max voltage for them my mind say's
it 7.2V but I wanted to check
malcolmfrary:
I think they were good for 8.4 (7 cells), any more volts and the output driver circuit would incinerate itself. (Easily recognised - a very black resistor over a very black bit of PCB, normally with some melted solder and a curly bit of copper tracking separated from the board)
andygh:
Yes, just had a look & the label reads 6 - 8.4V O0
gingyer:
Thanks for the info I always had 6v going thru them
and I wanted to make sure they were not for 12v
nightowl2912:
Hi All,
sorry too but in but do they have a built in B.E.C
Andy
Navigation
[0] Message Index
[#] Next page
Go to full version