Topic: split pins (Read 2737 times)

regiment · « **on:** July 28, 2009, 03:00:19 pm »

trying to find stanchions for a boat,about one inch long and as thick as a drawing pin the sharp bit. or cotter pins would do, trying squires but nothing on the net for them cannot seem to get them on phone

Bryan Young · « **Reply #1 on:** July 28, 2009, 04:34:18 pm »

James Lane makes pretty good ones at reasonable cost. Also operates under "Display Models" and advertises in the various mags. BY.

regiment · « **Reply #2 on:** July 28, 2009, 07:36:21 pm »

thanks any e mail address

Martin (Admin) · « **Reply #3 on:** July 28, 2009, 08:31:18 pm »

I would like some brass spilt pins to fit a 1mm hand rail about 2-4 mm from the side walls, what do I need?
Where do I get them from?

Colin Bishop · « **Reply #4 on:** July 28, 2009, 08:42:56 pm »

Squires probably Martin or go for Amati part 4703 at Cornwall Model Boats: http://www.cornwallmodelboats.co.uk/acatalog/amati_eyebolts.html

Colin

tigertiger · « **Reply #5 on:** July 29, 2009, 01:53:22 am »

There was a discussion about split pins here http://www.modelboatmayhem.co.uk/forum/index.php?topic=17425.0 with a couple of suppliers mentioned.

I got mine from
"www.grsuk.com"
I think they only stock 1/16" pins. The loop/hole at the top is perhaps too large as they are at least 1.5mm dia. So perhaps a smaller size if you can find one.

DickyD · « **Reply #6 on:** July 29, 2009, 08:22:12 am »

James Lane[display models] 30 Broadway, Blyth, Northumberland, NE24 2PP,
Tel 01670 352051

News:

Author Topic: split pins (Read 2737 times)

regiment

split pins

Bryan Young

Re: split pins

regiment

Re: split pins

Martin (Admin)

Re: split pins

Colin Bishop

Re: split pins

tigertiger

Re: split pins

DickyD

Re: split pins