Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Stanchions for model of deep sea tug "Lloydsman"  (Read 2048 times)

Lotus1

  • Shipmate
  • *
  • Offline Offline
  • Posts: 3
Stanchions for model of deep sea tug "Lloydsman"
« on: June 06, 2012, 07:59:24 pm »
Hi! Lotus1 back on the air, and still a member of the Norwich Model Boat Club, I am progressing with the scratch building of the deep sea "Lloydsman" tug, and I am now looking at producing the stanchions, I know you can obtain these in the scale I require from "Squires" or from "Display Models" but I am not to keen on the cost involved for about 200 units, so do any of you guys out there have any suggestions how I can overcome the problem? such as building a jig, or do I have to bite bullet and buy them. Thanks for your halp in advance.
Logged

nemesis

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,088
  • Location: North Shields. Northumberland
Re: Stanchions for model of deep sea tug "Lloydsman"
« Reply #1 on: June 06, 2012, 11:01:54 pm »
Hi, Try James Lane of Display Models, of Blyth, Northumberland. You get the wire as well for the rails. Nemesis
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 1.016 seconds with 17 queries.