Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Position of a water jet.  (Read 1879 times)

jezzahealy

  • Shipmate
  • *
  • Offline Offline
  • Posts: 6
Position of a water jet.
« on: October 15, 2017, 08:44:23 pm »
Hi,

I am planning on making a model of Mucho Gusto.http://www.classicwoodenboatplans.com/mucho-gusto/  I have a Graupner Water Jet unit which I was planning of installing. It is the white and red water jet they produced.
I any advice on the water jet. Is there e vertical position which the water jet should be set to?

I recall reading somewhere, that the the shaft in the until should be on the water line when the boat is stationary in the water. Is this correct? If so could the hight of the unit be reduced, by removing some of the inlet to lower it in the boat?

Any advice would be greatly appreciated.

Jeremy
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.344 seconds with 17 queries.