Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Lifeboat ISH  (Read 2511 times)

coch y bonddu

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 376
  • Model Boat Mayhem is Great!
  • Location: Bethesda
Lifeboat ISH
« on: January 23, 2019, 09:08:11 pm »
I remember on one of the Shannon builds someone reccomending a set of Bellows for the push rods....this is not for a shannon but the bellows for the pushrods looked a lot shorter than the ones I have seen...can anyone please give me a link to them thanks




Dave
Logged

Taranis

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,300
  • Balne Moor MBC
  • Location: Yorkshire
Re: Lifeboat ISH
« Reply #1 on: January 23, 2019, 09:30:47 pm »
Logged
ANDY
You’ll only know your best effort if you don’t give up.

coch y bonddu

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 376
  • Model Boat Mayhem is Great!
  • Location: Bethesda
Re: Lifeboat ISH
« Reply #2 on: January 23, 2019, 10:34:42 pm »
Thanks I was pretty sure it was yourself but wasn't 100% sure THANKS




Dave
Logged

Taranis

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,300
  • Balne Moor MBC
  • Location: Yorkshire
Re: Lifeboat ISH
« Reply #3 on: February 02, 2019, 10:50:21 pm »
Of course the most important part is ensuring no collision of parts with helm and buckets.
With many hours on the water the servo rods have never disengaged so no further additions are needed

Videos



Logged
ANDY
You’ll only know your best effort if you don’t give up.
Pages: [1]   Go Up
« previous next »
 

Page created in 1.042 seconds with 18 queries.