Topic: Taranis X9D assign throttle problem (Read 1668 times)

Pragmatist · « **on:** July 02, 2019, 01:42:56 pm »

So I’ve managed to assign the rudder to the right hand stick successfully however I cannot get the motors turning. I apply throttle and there is a double bleep from the speed controller and the left hand motor turns a few mm’s then nothing. I know everything in the boat works properly so I’m guessing it’s just the complexities of the TX.

kinmel · « **Reply #1 on:** July 02, 2019, 06:54:29 pm »

In model menu try the following first steps...

page 5/13 "INPUTS" set I01 to 100 01 sets channel 1 to 100% travel of input 01
page 6/13"MIXER" set CH1 to 100 01 sets CH1 to 100% mixing with 01

page 7/13 "outputs" set CH1 to name 0.0 0.0 100.0 sets output to positive values only
page 8/13 "curves" set CV1 to +100 0 +100 all movements of stick give forward power ( jet drive motors don't use reverse )

Pragmatist · « **Reply #2 on:** July 02, 2019, 07:10:23 pm »

Thanks, will give that a try.

News:

Author Topic: Taranis X9D assign throttle problem (Read 1668 times)

Pragmatist

Taranis X9D assign throttle problem

kinmel

Re: Taranis X9D assign throttle problem

Pragmatist

Re: Taranis X9D assign throttle problem