Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Action P105 Setup - Help!  (Read 1916 times)

Charlie

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 751
  • I spend far too much time on Model Boats Mayhem!
  • Location: Sussex
    • My Youtube Channel
Action P105 Setup - Help!
« on: July 11, 2020, 12:25:12 pm »
I’ve been trying to program my Action Electronics P105s, but without any success. I have read the instructions several times. I want to use them for the Waterjet Brushless ESC and Reversing Servo Application. I have connected the servo to J1 and the ESC to J2. I switch on and immediately press the programming button, until the yellow LED is lit for more than 2 secs. I move the tx stick down to indicate the Reverse position. I then press the button which should activate the yellow led. But instead the red led just stays lit. What am I doing wrong? I have previously connected the ESC and servo directly to the receiver, and all works ok. Has anyone else used these and got them to work? Got any tips?
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.011 seconds with 16 queries.