Ok well I say 'another' because this is the second one I have made. I started it in the morning around 10.00ish and was finished in the afternoon by around 16.00.
This is the process
Drill holes and test insert the bolts. The bolts along with wingnuts will be used to hold on the bottom removable base to the access to the inside to clean it out if it's used.
Remove the bolts and saw off the bottom 25mm
Mark out the area to cut out
Start to drill out around the edge, this is the point where I wish I had a big lathe to turn it out
-
Drill a bigger hole to help the chopping out with the chisel
Start the cut out process
The end of stage 1 chopping out
The end of stage 2 chopping out
After a little tidy up install camera
Connect the camera cable and fix it to the shed
-
A potential tenant when they start nesting