Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Graupner Water jet - Moonraker  (Read 983 times)

sailorboy61

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 346
  • Location: Wirral, UK
Graupner Water jet - Moonraker
« on: September 16, 2012, 11:22:16 AM »

Well my second hand Moonraker has arrived, so trying to strengthen her up, fix a few broken frames and set up the motors.

It has 900BB Turbos installed, but one of the jet shafts has quite a bit of play, such that at one end it (presumably the prop part), touches and stops me turning the shaft. Obviously not too good, though probably can be set up with the coupling to stop this, but wondering if there is any adjustment to the shaft travel. Unfortunately I don't have the instructions.

Anybody with any experience of these and suitable advice?

Thanks.
Logged
Pages: [1]   Go Up