Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Bow thruster advice sought  (Read 1981 times)

dougal99

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,412
  • Huntingdon, Cambs, England
  • Location: Huntingdon, England
Bow thruster advice sought
« on: June 27, 2009, 11:56:09 am »
I am fitting a Raboesch bow thruster to my current project and am seeking some advice from members who may have used them. Sholuld I use some form of sealant, such as paraffin wax, on the seal between the motor mount and the blade housing or are the screw clamps sufficient?

Thanks in anticipation

Doug
Logged
Don't Assume Check

catengineman

  • Guest
Re: Bow thruster advice sought
« Reply #1 on: June 27, 2009, 12:32:42 pm »
Not sure about if your BT is a paddle or prop type but I have taken my BT apart in Tito several times and had no problem when refitting I just use some petroleum jelly around the sealing edges.

my one is the paddle type.

R,
Logged

Chuffy

  • Guest
Re: Bow thruster advice sought
« Reply #2 on: June 27, 2009, 12:48:11 pm »
Use petroleum jelly myself, It won't attack the seals either.
Logged

dougal99

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,412
  • Huntingdon, Cambs, England
  • Location: Huntingdon, England
Re: Bow thruster advice sought
« Reply #3 on: June 27, 2009, 05:01:51 pm »
Thanks I'll go that way then.

The BT is the paddle type btw.

Cheers

Doug
Logged
Don't Assume Check
Pages: [1]   Go Up
« previous next »
 

Page created in 0.013 seconds with 17 queries.